08905155A
-
9
-
IR OUT
Connect a standard IR Emitter (283D, for example) from the IR OUT port on the front of the D5IP to
the IR receiver on the front of the audio source. For sources that have an IR Input port on the back of
the unit, use a 3.5mm to 3.5mm mono interconnect cable instead.
Rear Connections
D5KP Amplified Touch Pad
When utilizing the D5IP as a means to connect a Local Source to a specific zone of a D5RH-based
system, rear connections consists of plugging in a CAT-5 wire terminated to an RJ-45 connector
wired to T-568A standard to the RJ-45 jack on the rear of the D5IP. The other end simply plugs into
the LOCAL PORT RJ-45 jack on the rear of the zone’s D5KP Amplified Touch Pad.
D5XH DDS Expansion Hub
When utilizing the D5IP as a means to connect an audio source to a D5XH DDS Expansion Hub in
stand-alone mode, rear connections consists of plugging in a CAT-5 wire terminated to an RJ-45
connector wired to T-568A standard to the RJ-45 jack on the rear of the D5IP. The other end simply
plugs into the SOURCE LOOP IN RJ-45 jack on the rear of the D5XH.
Settings/Adjustment
There is one LED on the front of the D5IP that monitors the input level of the connected source.
There are two sets of DIP switches on the rear of the unit (marked “GAIN”) designed to adjust the
input level of the connected source.
Note: The GAIN DIP switches are only for Analog Inputs. The Digital Coaxial and Digital Optical
Inputs do not utilize these switches.