08905155A
-
10
-
Adjusting Analog Audio Source
Input Level
Once all connections are made, the Analog Audio Source should be adjusted to prevent clipping
(distortion) before the D5IP is mounted in place. To adjust the Analog Audio Source Input Level:
1. Ensure that the Analog Audio Source is connected properly.
2. Power up the source and turn on an audible signal (Press PLAY, tune to a station, etc.).
3. Select the Source from the zone’s D5KP Touchpad. If it is a Local Source connected to a
D5KP, select LOCAL. If it is a System Source connected to a D5XH, select the appropriate
Source Input on the Zone’s D5KP.
4. Adjust the zone’s volume to a normal, comfortable listening level.
5. Observe the CLIP LED on the front of the D5IP. If it lights up constantly or consistently, the
source’s output level is too high and needs to be adjusted.
6. Adjust the GAIN DIP switches according to the following table:
Setting
Function
All Down
No GAIN
DIP Switch 1 & 3 UP
+4dB GAIN
DIP Switch 2 & 4 UP
+8dB GAIN
DIP Switch 1, 2, 3 & 4 UP +10dB GAIN
Note 1: Try each setting and monitor the CLIP LED until it does not illuminate.
Note 2: GAIN adjustment must be set for both Right and Left Inputs.
Both settings should be the same.
7. Mount the D5IP and install Trim Ring.
Specifications
Sampling Frequency
48kHz
Digital Audio Resolution
24 Bit, Stereo
THD+Noise Full Scale
0.004%
Dynamic Range
96dB
L/R Crosstalk @ 1kHz
-90dB
Frequency Response
20Hz-20kHz +/- 0.1dB
Max Output Distance
800 ft
GAIN DIP Switches
All DOWN
DIP Switch 1&3 Up
DIP Switch 2&4 Up
DIP Switch 1,2,3&4 Up
No GAIN
+4dB GAIN
+8dB GAIN
+10dB GAIN
Dimensions
H x W x D
4 1/4" x 1 3/8" x 2 3/4"
(10.8 cm x 3.5 cm x 7.0 cm)
Weight
0.28lbs (0.13kg)