Xantech COMPAUDEXT, User Manual

Page: 3 / 7

- 3 -
OPERATION NOTES
READ THESE NOTES BEFORE INSTALLING OR
OPERATING THE COMPONENT EXTENDER SYSTEM
•
Use industry standard Category-5e (CAT-5e) cable to operate the Component with Audio
Extender system. CAT-5e cable is preferred.
•
Please connect all the cables between the source and the Component with Audio Extender
before powering up the Component with Audio Extender unit.
•
The Component with Audio Extender units is housed in a metal box for better RF shielding.
INSTALLATION INSTRUCTIONS
1. Connect the Component output of your source / receiver to the input on the Component
Extender Sender Unit.
2. Connect the audio output of your source / receiver to the input on the Component Extender
Sender Unit.
3. Connect the Component input of your display to the Component output on the Component
Extender Receiver Unit.
4. Connect the audio input of your display to the Component output on the Component Extender
Receiver Unit.
5. Connect a CAT-5 cable between the Component Extender sender and receiver’s CAT-5 input.
6. Power on the display first and then the source.
Note: Any of the 3 RCA lines can be used for any color. Both ends will need to be matched for the
signal to be passed through correctly.
BRIGHTNESS AND FOCUS TRIM PODS
If your picture is too dark or if you see a “ghosting” effect on your display, then the trim pods will help
correct this problem. If your picture is too dark then the brightness trim pod will help brighten up your
display. If your picture has a “ghosting” effect and/or noise, then the focus trim pod will help sharpen
up your picture. Turn trim pods to the left and right to eliminate any noise on your picture.