08905076A
-
3
-
DISASSEMBLY
You may find it necessary, from time to time, to disable the Key Module to change buttons for
system updates, etc. Proceed as follows:
1. Remove the Key Module from the PM110 or LM110 or EM110 by pulling upward at the 18-pin
connector end of the module.
2. Grasp the Key Module with both hands, with the buttons facing you.
3. With the fingers of each hand, pull outward on the lower edges of the
Key Module Shell
.
4. As the 4 small retainer tabs recede from the slots on the
Key Modules Shell
, press down on
the buttons with your thumbs.
5. The
Key Module Shell
should now move away from the
Key Module PCB & Base
assembly.
CAUTION: To avoid damage, be sure not to use excessive force when
executing this disassembly procedure.
6. When you have made the desired button changes, reassemble the unit using the steps given
under INSTALLATION (section shown above).
