3
Controllers
CALLING AND ANSWERING
To use the cordless telephone to make calls or to answer calls, do everything as you would do without
the Fone Link -- except add the asterisk (*) key to the routine. When you are ready to dial, press the
asterisk (*) key first -- this connects you to the telephone line and gives you a dial tone. When you answer
the telephone, press the asterisk (*) key to connect to the calling party.
PROGRAMMING
Before programming the Fone Link, press the RESET button on the rear panel. This will clear any data
stored during factory testing. Do not push this button again unless you wish to erase ALL of the
programming information which you have entered. There is no way to restore this information except
by re-programming.
1. Activate the cordless phone
(go "off-hook" with a wired phone).
Since cordless phones differ with brand and model, do what is necessary in order to make a call,
but do not "dial". You should not hear a dial tone.
2. Press the PROGRAM button
on the rear panel of the 710 Fone Link.
The
PROGRAM
LED on the front panel will light up.
3. Place the hand-held remote controller three or four inches from the front of the Fone Link
,
pointing directly at it.
The Fone Link must receive the infrared output from the hand-held remote controller in order to
memorize its commands.
4. Press and hold the button key on the phone that you wish to program
[any key except the
asterisk (*)]. The
LEARNING
LED on the Fone Link will light up.
5. Press and release the button on the remote controller that you wish to store
.
The
PROGRAM
LED on the Fone Link will flash while it is storing the information. When the
information has been stored, the
LEARNING
LED will turn off.
6. You can now release the phone button key.
You have now programmed one function; one telephone button key has been programmed to
send the same infrared command as the button which you had pressed on the hand-held remote
controller. Steps 4 through 6 must be repeated for each command that you wish to store. Eleven
(11) different functions may be stored in this manner.
NOTE:
The asterisk (*) key cannot be programmed.
7. After programming the last function, press the PROGRAM button again on the Fone Link.
The
PROGRAM
LED will turn off. This takes the Phone Link out of the programming mode.
TESTING THE SYSTEM
• Activate the cordless phone.
• Press any of the telephone keys which you have programmed.
• The
OUTPUT
LED should flash and the audio/video equipment should execute the command.
GOING "ON HOOK" AND "OFF HOOK"
If a telephone call comes in while you are using the cordless telephone for remote control, the telephone
cannot ring in the usual manner. Instead, the ring will be heard in the telephone earpiece.
• Answer the call by pressing the asterisk (*) key on the phone. You will hear the calling party. This is
called "OFF-HOOK".
• When the call is completed, go "ON-HOOK" by pressing the asterisk (*) key again if you want to return
to IR control operations. If you do not want to continue IR control of your system, simply turn off the
cordless phone (or hang-up a wired phone).
710-00
