Freedom XF102- User Manual
VII Troubleshooting
Problem
Cause
Solution
A. little or no material flow
1. nozzle clogged
2. suction tube clogged
3. material volume setting turned too far to the right
4. suction tube loose
5. container is loose
1. clean
2. clean
3. turn to the left
4. insert
5. tighten the container
B. material leaking
1. nozzle loose
2. nozzle worn
3. nozzle seal worn
4. material build-up on spray pattern dial and nozzle
5. atomizer used or stored in an inverted or sideways
orientation
1. tighten
2. replace
3. replace
4. clean
5. disassemble atomizer from motor/blower
assembly and used compressed air to remove liquid
from atomizer assembly. If liquid has entered motor
/blower used compressed air to remove all liquid and
allow to dry overnight. Replace motor/blower
assembly if erratic operation occurs after drying
overnight.
C. atomization is too coarse
1. material volume setting too far to the left
2. nozzle clogged
3. too little pressure build-up in container
1. turn to the right
2. clean
3. tighten container
D. spray jet pulsates
1. material in container is depleted
1. refill
E. pattern runs, sags or remains wet
1. applying too much material
1.adjust material flow or increase movement of
atomizer
F. too much over-spray
1. atomizer too far from target area
2. too much material applied
1. reduce distance
2. turn material volume setting to right
G. pattern is very light and splotchy
1. moving the atomizer too fast
1. adjust material flow or decrease movement of
atomizer
H. large cloud of disinfectant
1. atomizer too close to target area
1. move atomizer away from target area
and reduce disinfectant flow
I. disinfectant not drying
1. atomizer too close to target area
1. move further away (4 feet or greater)
J. disinfectant drying too quickly
1. atomizer too far away from target area
1. move closer
K. battery pack not charging
1. charger not plugged into live outlet
2. pack too cold to charge, green LED on charger is on
3. pack too hot to charge, green LED on charger is on
4. defective pack
5. defective charger
1. plug charger into outlet and ensure green LED is on
2. move pack and charger to warm location, 60-80°F.
Pack will charge upon reaching a safe temperature.
3. move pack and charger to cool location, 60-80°F.
Pack will charge upon reaching a safe temperature.
4. try another charger. If still not charging, replace
pack
5. try another pack. If still not charging, replace
charger
