aligned to the hole on T305 (
Figure
10
)
Figure 10
Step 2:
Tight the hand screw on the right side of cable clamp (
Figure 11
) until the cable clamp can
move loosely.
Figure 11
Step 3:
Plug each cable into corresponding port, and collect each cable into cable channel (
Figure
12
). To secure the cables, fasten two hand screws (
Figure 13
).
Figure 12 Figure 13
6.
P
OWER
O
N THE
T
ERMINAL
Step 1:
Connect the power cord to the power adapter
Step 2:
Plug the power adapter into an electrical outlet or into a surge suppressor (recommended).
Step 3:
Plug the power cord into the power jack (
Figure 14
)
Figure 14
7.
U
SING THE
C
ONTACTLESS
C
ARD
R
EADER
Contactless reader antenna is around the display. It will light up and blinking the 1
st
LED when
xCE_T305 is powered on and that means reader is working normally.
Place contactless card near the display (
Figure 15
). The contactless antenna should detect the card
and read the card data.
Note:
Make sure the xCE_T305 contactless antenna is away from other contactless antenna at least
8 inches to avoid any interference.