Operating Temperature: 0
o
C to
40
o
C
3.
R
EMOVAL
P
ROTECTION
Two “Removal Protection” sensors (
Figure 7
) are located at the right side of front. When install
this module, make sure these two sensors are pressed firmly against kiosk bezel.
Figure 7
4.
I
NSTALL
T305
ON YOUR KIOSK
Step 1:
To fix T305 & P95 on a kiosk's front panel, please make sure the surface is plate and refer
to below screw locations and torque value.
Step2:
Check all the screw holes of T305 to avoid any damage.
Step3:
To make the fixing points on the kiosk, please refer to
Figure 8
.
Step4:
Lock 12 screws by following the sequence shown in
Figure 9
, and contact the rubber with
kiosk cover closely.
(NOTE: Torque 4~4.5 kgf-cm for each screw to fix.)
The above information is the exclusive intellectual property of XAC Automation Corporation and shall not be disclosed,
distributed or reproduced without permission of XAC Automation Corporation.
XAC AUTOMATION CORP. shall not be held liable for technical and editorial omissions or errors made herein; nor for
incidental or consequential damages resulting from the furnishing, performance or use of his material.
XAC Automation Corporation
886-3-577-2738
www.xac.com.tw