1.
P
ACKAGE
C
ONTAINS
-
TP72-HUB2.
-
Thermal paper. (Figure 1)
Figure 1
2.
P
ORT
C
ONFIGURATION
-
There are several ports at the back side of TP72-HUB2.
-
Support four USB host ports located on rear of left side. (Figure 3)
-
Support one USB device port located on rear of right side. (Figure 4)
-
Support one RS-232 ports of RJ-12 offset keyed connector. If TP72-HUB2 uses a peripheral
device with this type of connector and interface, plug it into the RS-232 port on the back of
the Cash drawer port (RJ11). (Figure 5)
-
Support Ethernet port (RJ45) for communication over Ethernet. (Figure 6)
Figure 3
Figure 4
Figure 5
Figure 6
3.
P
OWER
O
N
Plug the power cord into the power jack and plug the power adapter into a 120-volt electrical
outlet or into a surge suppressor (recommended) after the power cord is connected to the power
adapter. (Figure 7) Press and hold the power button (3 seconds) at the left side of device (Figure 8)
until the system is booted up.
Figure 7
Figure 8
While the system is booted up, the “Power” LED will light in green. (Figure 9)
Figure 9
