14
To Dim/Bright a light plugged into an X10 Home Automation module:
press its Unit Code on the key
pad (11) and then press
VOL+ / -
(10).
To turn ON All the Home Automation Lamp modules:
Press the Power key (1).
To turn Off Al l the Home Automation modules (Lamp and Appliance):
press the Mute key (12).
5.2. Changing the Home Automation House Code
The default house code is A and in the majority of cases it is not necessary to change this setting except if
there is interference from neighbouring X10 systems. In that case:
1. Press and hold
SETUP
(4) until the LED lights continuously.
2. Release the
SETUP
(4) button.
3. Use the digit keys to enter the number equivalent to the chosen home code (1=A, 2=B, ... 16=P).
4. Press the
--/-
(14) to confirm your command. The LED will turn off.
Note
: The code you have chosen has to be the same as the one selected on the Transceiver module
(TM13 or Security console) and all other X10 Home Automation Modules, with which you use your remote.
5.3. Programming the Home Automation IR/RF mode
Your PC remote control can control your electric appliances using infrared signals (via an infrared mini-
controller IR7243) or RF signals (via a transceiver module TM13). The
key is set to RF mode by
factory setting.
To program the
(AUX) key to send an Infrared signal, proceed as follows
1. Press and hold
SETUP
(4) until the LED indicator (2) lights steadily. Release
SETUP.
2. Press and release the
(AUX) key
3. Enter the 3 digit code 821.
4. The LED (2) turns off after the last digit is entered. If you entered a wrong code the LED blinks for 3
seconds and then goes off.
To program the
(AUX) key to send HF radio signals, proceed as follows
1. Press and hold
SETUP
(4) until the LED indicator (2) lights steadily. Release
SETUP.
2. Press and release the
(AUX) key
3. Enter the 3 digit code 820.
4. The LED (2) turns off after the last digit is entered. If you entered a wrong code the LED blinks for 3
seconds and then goes off.
6. Troubleshooting
6.1 A/V mode
The remote doesn’t work or loses codes entered
• Confirm with your original remote that the equipment works correctly.
• Make sure that you have pressed the corresponding mode key of the equipment or device that you want
to control.
• If the listed code does not work, try the AUTOSEARCH method or enter the next code of that brand.
• Check that the batteries have the correct polarity position.
• The programming of the remote requires 4 AAA Alkaline batteries (new). If the remote looses codes
within a few days/weeks the problem can be solved by using 4 new batteries from the same brand.
• If the LED is lit permanently, in general it will be necessary to replace the batteries.
• Set the remote back to factory default (see end of this paragraph).
6.2 PC mode
NO mouse or PC operation at all
• Ensure the remote is in PC mode by pressing the PC button before you operate the mouse pad, mouse
buttons or any of the other keys.
• Ensure that the CM21E Receiver is plugged into your USB port.
Summary of Contents for UR86E
Page 7: ......
