- 4 -
Product Set-up
1. Unpack all of the contents of the X-Tronic 9050-PRO unit.
2. Inspect the unit and accessories for any damage. If damage is
detected, please contact X-Tronic immediately (see back of manual
for contact information).
3. Remove the 2 red screws on the bottom of the unit.
4. Place the hot air pencil into the holder next to the unit.
5. Plug the anti-static ground wire with alligator clip into the back of the
unit.
6. Plug in the power cord to the back of the unit.
7. Plug the other end of the power cord into a GROUNDED AC wall
outlet.
8. The unit is now ready to be powered on with the switch located on
the front of the unit.
WARNING
You must remove the 2 red screws on the bottom of the unit mentioned
in Step 3 before using the unit. Failure to follow this precaution could
result in undesired results and harm your unit!
