Exposure Adjustment
Exposure adjustment: under the environment of extremely poor visibility and the image
is not clear due to the brightness, however, the brightness is adjustable: 9 grades for
exposure adjustment.
■
While the camera
’
s image is displayed -
》
press “
↑
or
↓
” to adjust the grade of
expsure, every press adjusts one grade.
Photo Preview & Delete
n
Press the
“
ON/OFF
”
button to turn the monitor
’
s display ON
n
Preview: long press “
↓
/
key", display the latest pictures which are ranked by
time, the latest one is on the top list.
n
Check: press "
↑
up
"
key
,
check previous photo-
》
press"
↓
down key
"
, check the next
photo.
n
Delete: press "Delete" of “
FUNC
”-
》
press "
↑
Up"
or
"
↓
Down"
key to select
"yes"
or
"No"
-
》
press "OK" to confirm.
n
Exit: finish the operation, press "OK" key to exit photo preview.
Match code setting
By default, the monitor is paired with the camera. These instructions apply to
pairing a second or third monitor.
n
Handset is in shutdown mode-
》
long press power button-
》
"Welcome" would be
displaied on the screen-
》
please immediately click the power button-
》
screen would
be displayed "Pairing";
n
Meanwhile, click "
Reset
" key of outdoor unit-
》
red lamp flashes and then match the
code.
n
If there is image on handset, code match succeeded; otherwise, match the code
again.
When pairing an extra unit you need to press the reset button on the outside unit twice,
only press during one second, not longer. Note that this procedure is different from
pairing the indoor unit from the XT-WG01.
Please follow the steps below for pairing extra indoor units:
1.
press long on the outside unit reset button until the outside unit will sound a “di”
alarm and a blue LED light shines. Turn on the first indoor unit and press on the
power button several times (Quick press), if you see a picture on the monitor the
action you performed was successful.
2.
press twice on the outside unit reset button (LED light shines and alarm sounds
continuously), now turn on the second indoor unit and press the power button
several times (Quick press) until you see a picture on the monitor.
Note: a outdoor unit could max. support 3 handsets. If you match the code forth
time, it would delete the previous three codes.
Battery and Charge
●
Be sure the activity of the battery, please fully charged the new battery.
●
When the outdoor unit is at low power, the lamp of launcher would flash. It remains
you to charge.
●
The battery of outdoor launcher can be changed or charged by USB. The red light
keeps bright.
●
When the Indoor monitor is at low power (
≤
a bar), the red indicator lamp will flash
every second, please charge immediately
●
The Indoor monitor can be charged by the table type holder or by USB, green light
keeps bright.
●
Charge-and-work supported. When the battery is charged fully, it auto stops
charging.
●
Battery type: high-quality lithium battery, please use the BP-6M model battery if it
needs replacement
●
Charging and battery attentions, please reference the chapter “Warms and attentions”
in this manual
Notice:
Under the low power, display, photo-taking functions can’t work normally.
