9
Getting Started
1. Open scooter carton and remove your XMB-320. Inside you will find the following contents:
1. X-Treme XMB-320 Mobility Scooter
2. User Manual
3. Tool Kit
4. 24V UL Battery Charger
2. Make sure your handlebar
components are as shown in
Figure 1. Loosen the flat bolt
in the handlebar. Remove the
pin and insert the connector to
the handlebar. Insert pin and
tighten bolt.
3. Turn and tighten the folding
unit (shown in Figure 2) to
secure the handlebar.
4. Insert seat post and adjust to desired height as shown in Figure 3. Tighten seat posts
clamps to secure.
5. Loosen the front shaft nut and remove the washer from the front axle. Place front wheel in
place and slide the front axle back through and replace washer and nut and tighten as shown
in Figure 4.
Charging
Your scooter comes charged out of the carton. We still recommend charging the unit for
6-8
hours
prior to its first use. We also recommend charging your scooter after each use and prior
to storage. Do NOT charge for more than 8 hours at one time, batteries may overcharge and
result in damage.
1. Make sure you unit is turned off.
2. Locate the charging socket on the scooter and plug in your charger to the socket.
3. Plug the charger into the power source.
When first plugged in, the charger has one red light that will illuminate at the same time,
indicating that the charging process has started. Once the light on the charger turns red &
green, you may remove the charger and close the safety cap.
Fig 1
Fig 2
Fig 3
Fig 3
Fig 4
Summary of Contents for XMB-320
Page 12: ...12 WIRING DIAGRAM ...
