8
B. Adjust running belt alignment.
When you use a walking machine, the pressure on the running belt is unbalanced because the force on both feet is
different, resulting in the running belt deviating from the center. This deviation is normal, and when no one runs on
the running belt, it automatically returns to the center. If you can't get back to the center, you need to run back to the
center.
Run the treadmill without load, speed to the sixth gear, observe the distance from the running belt to the left and right-
side bars:
● If to the left, use a hexagonal wre
nch to clockwise rotate the left screw 1/4 lap.
● If to the right, use a hexagonal wrench to rotate the right screw 1/4 lap
clockwise.
● If the running belt is still not in the middle, repeat the above action until adjusted to the middle.
After adjusting the running to the middle, adjust the speed to the sixth gear, and observe the deviation of the running
belt and the smooth running. If there is any deviation, repeat the adjustment steps.
Warning! Do not over tighten the roller! This will cause permanent damage to the bearing!
10. Lubricating oil
The walking machine is lubricated when it leaves the factory, but the lubricity of the walking machine is often
checked, which helps to keep the walking machine in the best condition. The treadmill must be lubricated after one
year or 100 hours of operation.
After 30 hours or 30 days of use, in the treadmill static state, pull up the running belt from the side to touch the
platform surface as far as possible, if you feel the lubricating oil, you do not need to add lubricating oil; If you touch
the surface with a strong sense of dryness, follow the following instructions for refueling. (Use non-oil lubricants)
How to add lubricating oil, please follow the following way to operate, open the left front side of the edge bar
refueling decorative cover, with scissors or knife to cut the lubricating oil bottle according to the size of the drawing,
and then press the bottom icon refueling, Please pay attention to inserting the rod in the oil pipe on the platform.
