vipPAQ Hardware Installation Manual (Ed. 2c)
4 Cut the Mounting Bar
If the mounting bar is not already precut to the correct length, proceed as followed:
1. Measure the exact distance (+/- 0.5 mm) between the foreseen mounting
areas.
2. Subtract 82mm (3.23“) from the measured distance
3. Precisely cut the bar to that length
4. Insert and clew bolt and roll according to the below drawing. Use “Loctite 648
or similar to clew the parts.
This graph shows one end of the bar. The other end needs to be equal.
3
