X-Rite Color i7, Operation Manual

Page: 19 / 27

C O L O R I 7 O P E R A T I O N M A N U A L
17
Film Measurements
1.
Attach the appropriate stop to the base plate and clamp to the carriage base with the thumb
screws. For total measurements, make sure the stop is position against the sphere before
tightening the thumb screws. For LAV, sample contacts the sphere. No stop is recommended.
Figure 11. Base Plate with Stop and Clamp Attached
2.
Pull the clamp back and position the sample between the clamp and stop (refer to figures 6
and 7). You may want to temporarily tighten the carriage base thumb screw to hold the clap
in place while positioning the sample. Slowly release the sample clamp/carriage base to
secure the sample.
Liquid Measurements
1.
Loosely attached the flow cell stand assembly to the carriage base with two thumb screws. A
clamp is not required for this measurement.
2.
Slide the flow cell stand forward and tighten the thumb screws.
3.
Insert the cuvette into the flow cell stand.
Figure 12. Flow Cell Stand (Total Measurement)
Sample stop for SAV, MAV,
and 17 mm. Stop not
recommended for LAV.
Sample clamp
Carriage base
Clap thumb screws (2)
Stop thumb screw (2)
Carriage base thumb screw
Base plate