C H A P T E R O N E
1-4
As an added feature to conserve battery life, the instrument
automatically powers down when it is not in use. You can
define the amount of time it takes to initiate a power-down
within the instrument configuration options
(see Section Four).
Taking a measurement or pressing a key turns the instrument
back on during a power-down. However, if the instrument is
turned off with the battery switch you must turn it back on with
the battery switch.
Charging the Battery Pack
NOTE:
The battery pack must be installed before plugging in the AC
Adapter.
Only use the AC Adapter supplied or the optional battery
charger (available through X-Rite) to charge the battery pack.
The battery pack must remain in the instrument at all times to
operate.
Before initial “remote” use of the instrument, charge the battery
pack for approximately four hours. However, if immediate use
is required, the instrument can be operated “tethered” to the AC
adapter during battery charging.
To attach the AC adapter:
1.
Verify that the voltage indicated on the adapter complies
with the AC line voltage in your area. If not, contact
X-Rite or an authorized representative.
2.
Insert the small plug from the adapter into the power-input
connector on the instrument. (If you are using serial cable
SE108-92, you may insert the small plug into the power
connector at the end of the cable.)
3.
Plug the adapter into an AC wall receptacle.
Battery Switch
AC Adapter Input
Summary of Contents for 962
