Transportation
1.
Be sure to stop the engine while transporting
．
2.
Screw up the fuel tank cap securely and close the fuel valve to avoid fuel leaking
．
3.
In transportation by car, fix machine securely not to move nor to fall down
．
(In case of driving for long
distance or at off-road, tank out fuel from tank.
After Each Use
1.
Remove mud, dirt, etc., from the unit.
2.
Clean bottom face of the vibrating plate
．
3.
Check the air cleaner element and clean if necessary
4.
Check all nuts, bolts, and screws for tightness and retighten as necessary.
MAINTENANCE
Every 8 hours
Every 50 hours
Every 100 hours
Every 200 hours
Every 300 hours
Check
throttle cable
assembly
bolts for
loosening
Remove spark
plug
，
clean and
adjust the spark
plug gap to
0.6-0.7mm
(0.02-0.03 in.)
Clean the
urethane foam
in the same way
as described
above
Vibrator oil
check
V-belt
(clutch) check
Replace spark
if n necessary
Vibrator oil
replacement
Vibrator Oil Check
1.
Place the plate compactor horizontally on a flat surface
．
Make sure the compactor is level when
checking the oil in the vibrator assembly.
2.
Check vibrator oil level by removing the plug (vibrator oil gauge) as shown in below picture. The oil level
should be up to the oil plug. If oil is required, replace using SAE motor oil, as suggested in the table
Fig-1
．
3.
When changing the vibrator oil, remove the drain plug, and simply tip the compactor to drain the oil.
Note that the oil will drain more easily while it is hot.
6
