X-IO ISE-2 Series, User Manual

Page: 159 / 178

Xiotech—Proprietary 160337-000 Rev D, 30 September, 2013 Page 151
Appendix A: Quick Start ISE User Guide
Appendix A: Quick Start
For experienced ISE users needing only a summary of configuration procedures, this appendix briefly
describes the steps to set up an ISE using the Web Management Interface (Web-Mgt). For a detailed guide,
refer to “Initializing ISE” on page 41.
Quickstarting the ISE is detailed in the following sections:
•
Connect ISE Web-Mgt (below)
• Upgrade ISE firmware (page 152)
• Initialize ISE and storage pool (page 154)
• Create host (page 155)
• Create storage volume (page 156)
• Ongoing operations (page 156)
• System parameters (page 156)
Connect
This section briefly describes the steps to connect to the ISE Web-Mgt through a Web browser. For more detail
on this process, see “Terminology” on page 30.
1. Obtain the IP addresses or the host names of the Managed Reliability Controllers (MRCs) in the ISE from
the site network administrator.
2. Ensure that power is applied to the ISE by confirming that the green LEDs on the power supplies are illumi-
nated (see Figure 32 on page 37 and Table 24 on page 102). If the green LEDs are unlit, confirm that the
power connections at the rear of the ISE are good and that the power switches are in the
ON
position.
Once power is on, wait five minutes before proceeding (see Figure 32 on page 37).
3. Open a Web browser on any server attached to the storage network.
4. Link to one of the ISE MRC IP addresses (or host name), and the Login panel opens.
5. Click
LOGIN
.
The System Authentication dialog appears.
6. Log in with the default user name (
administrator
) and password. For a first-time login, the default password
is
administrator
.
First-Time Login
The first time an ISE is powered on, the factory-installed firmware must be upgraded to a current level and the
storage requires configuration. After initialization, if a firmware upgrade is available, apply the upgrade.