Front Panel
Rear Panel
Copyright © 2017 WyreStorm Technologies |
TX-70-4K Quickstart Guide | 170804
North America: 518-289-1294 | EMEA/ROW: 44 (0) 1793 230 343
2 of 4
A
B
C D E
F
A
B
C
D
E
F
Set (TX)
3 Position Dipswitch
Used to enable/disable long cable mode and configure RS-232 port operation. See
section for operation.
EDID
3 Position Dipswitch
Used to set EDIDs to correct resolution conflicts between the source and the display. See
section for operation.
Power LED
Solid:
The receiver is powered On
Off:
The receiver is powered Off
Status LED
Flashing:
The receiver is operating normally.
Off:
The receiver is Not operating normally.
HDCP LED
Solid:
HDCP content is present.
Flashing:
HDCP content is not present.
Off:
No signal.
LINK LED
Solid:
Link to receiver has been established.
Flashing:
Link to receiver has not been established.
Power Input
5.5mm Screw Down Barrel Jack
2-pin Phoenix Connecter
HDBT Out
8-pin RJ-45 female
HDMI In
19-pin type A HDMI female | Supports HDMI and DVI/D with adapter
IR TX
IR RX
IR TX - 3.5mm (1/8in) Mono Jack: Connect to the supplied IR emitter to control a local device from the remote display location
via HDBaseT.
IR RX - 3.5mm (1/8in) Stereo Jack: Connect to the supplied IR receiver to send IR to the remote display location via HDBaseT.
See
for more information.
RS-232
3-pin Phoenix Connector
Used to transmit RS-232 over HDBaseT to the remote location and for firmware updates.
See
section for more information.
Ethernet
8-pin RJ-45 female | 10/100 Mbps auto-negotiating
Connect to a Local Area Network or network device for Ethernet pass-through via HDBaseT.
