Copyright © 2018 WyreStorm Technologies |
RXV-70-4K Quickstart Guide | 180917
UK: +44 (0) 1793 230 343 | ROW: 844.280.WYRE (9973)
3 of 4
EDID Configuration
This receiver uses EDID pass-through from the display to the source. No configuration is required for EDID settings.
Setup and Configuration
RS-232 Mode Settings
The RS-232 connector is used to transmit RS-232 over HDBaseT to the remote
location and for firmware updates. Ensure that the RS-232 Mode switch in
the proper position for the operation being performed. This connection is only
available on version 1 of this product.
Set the mode switch to
Normal
to transmit RS-232
signals from the TX to the RX for controlling devices in
the remote location.
Set the mode switch to the
Update
position to install a
firmware update in either the TX or RX.
Troubleshooting
No or Poor-Quality Picture (snow or noisy image)
•
Verify that power is being supplied to the transmitter and receiver.
•
Verify that the fiber cable is properly terminated.
• Verify that the output resolution of the source and display is supported by
this extender.
•
If transmitting 3D or 4K, verify that the HDMI cables used are 3D or 4K rated.
• Verify that all source and HDBaseT connections are not loose and are
functioning properly.
No or Intermittent 3rd party Device Control
• Verify that the RS-232/Ethernet cables are properly terminated.
•
Verify that emitters/receivers are compatible with WyreStorm IR.
•
If using an IR control system, verify that it is connected using the
cable.
