Front Panel
Rear Panel
Output Channel
Indicator
1-6 (6x6) or 1-8 (8x8)
Displays the source input number currently selected for the corresponding output number.
IR Sensor
Receives IR signals from included handheld IR remote or attached emitter from IR control system for switcher control.
Source/Output
Navigation
Left/Right:
Output Selection
Up/Down:
Input Selection
Enter:
Confirm Selection
Power Input
8-pin RJ-45 female
Connect to the HDBT In of an HDBaseT receiver. See
HDMI/HDBaseT Wiring
for important wiring guidelines.
HDBT Out LED Operation
Green Solid:
HDBaseT link has been established with the receiver.
Green Flashing or Off:
HDBaseT link has NOT been established with the receiver.
Amber Flashing:
HDBaseT functioning normally and can establish a link with the receiver.
Amber Off:
HDBaseT has discovered a fault and cannot establish a link with the receiver.
HDMI IN/Out
19-pin type A HDMI female:
Supports HDMI and DVI/D (requires adapter-not included). See
HDMI/HDBaseT Wiring
for important wiring guidelines.
IR RX/Ext/TX
IR RX/Ext - 3.5mm (1/8in) Stereo Jack:
Connect to an IR receiver for matrix control (Ext) or IR pass-through (RX) via HDBaseT.
IR TX - 3.5mm (1/8in) Mono Jack:
Connect to an IR emitter to control a local device from the remote display location via HDBaseT. See
IR Wiring
.
Power
Power Switch: 0 –Power Off / I – Power On
Fuse Holder
IEC Power Cord Port
LAN
8-pin RJ-45 female | 10/100 Mbps auto-negotiating
Connect to a network router or switch for accessing the Web UI or matrix control via IP.
RS-232
9-pin DB9 Female
Used to control the matrix functions and firmware updates. See
RS-232 Wiring
.
EDID
4 Position Dipswitch:
Used to set EDIDs to correct resolution conflicts between the source and the display. See
EDID Settings
.
Copyright © 2016 WyreStorm Technologies |
wyrestorm.com
MX-0606-PP-POH v1 Quickstart Guide | 160815
North America: 518-289-1294 | EMEA/ROW: 44 (0) 1793 230 343
2 of 4
