14/136
This equipment generates, uses and can radiate
radio frequency energy and, if not installed and
used in accordance with the instructions, may
cause harmful interference to radio
communications.
However, there is no guarantee that interference
will not occur in a particular installation.
If this equipment does cause harmful
interference to radio or television reception,
which can be determined by turning the
equipment off and on, the user is encouraged
to try to correct the interference by one or more
of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the
equipment and receiver.
– Connect the equipment into an outlet on a
circuit different from that to which the
receiver is connected.
– Consult the dealer or an experienced radio/
TV technician for help
Product labelling:
This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions:
1
This device may not cause harmful
interference, and
2
this device must accept any interference
received, including interference that may
cause undesired operation.
Laser classification
The Würth WDM 30 generates a visible laser
beam that is emitted on the front of the device.
The device complies with laser class 2
according to:
IEC60825-1: 2007 Safety of laser products
Laser class 2 products
Do not look into the laser beam and do not
unnecessarily aim at other persons . The eye is
usually protected by preventive reactions such
as the eyelid closure reflex.
Labels
Position of the type label see drawing C
Care
– Clean the device with a damp, soft cloth.
– Never immerse the device in water.
– Never use aggressive cleaning agents or
solvents.
Warning
Changes or modifications not expressly approved by
Würth for compliance could void the user's authority
to operate the equipment.
Warning
Bodily harm due to laser beam!
– Do not look directly into the laser beam.
– Do not look directliy into the laser beam with
optical appliances (such as binoculars, telesco-
pes).
Würth WDM30.book Page 14 Wednesday, December 9, 2009 4:43 PM
