Würth PinPuller, Operating Instructions Manual

Page: 8 / 34

8
For your safety
This device will be
operated safely only if the
user fully reads the
operating instructions and
the safety regulations and
if he/she closely adheres to
all the indications stated
therein.
Before using this device always
check the cable and the plug. If
any defects are noticed do not use
it.
If the device is to be repaired, only
a specialist should do so. Never
open this device on your own.
Before executing any work on the device
itself, pull the mains plug.
Do not make any conditioned changes from
the structure to the device.
This device might generate strong magnetic
fields and consequently damage clocks,
magnetic cards or other data carriers.
People with pace makers must first seek the
doctor’s opinion before approaching the
work environment of this device.
It is advisable to wear protective goggles
and work gloves.
Before using the device the user should
remove jewelry, watches and any clothing
that contains high amounts of metal which
could heat up by induction.
Technical data
Resistance-welding equipment:
Article number 0691 500 290
Coupling voltage 220 – 230V
Mains frequency 50 – 60 Hz
Mains protection 16 A sloggish
Rated output 50% ED 2 kVA
Max. welding output 12 kVA
Max. secondary current 1.8 kA
Max. welding current 1800 A
Secondary off-load voltage 7 V
Weld time 0.01 – 2 s
Control current connecting joints and bayonet
fittings
XLR
Protection rating IP 21
Weight 16 Kg
Machine components
1 Control panel
2 Jack for weld gun
3 Current connecting joint for weld gun
4 Ground connecting joint
5 Current connecting joint for Dent Killer
6 Jack for Dent Killer
7 LED for weld gun welding times
8 LED for weld gun welding current
9 LED for Dent Killer welding times
10 LED for the welding current at the Dent Killer
11 LED for carbon electrode welding current
12 Autostart activation/deactivation LED
13 Program key arrow pointing up
14 Program key arrow pointing down
15 Display for welding times and current
16 Adjuster key for increasing values (+)
17 Adjuster key for decreasing values (-)
18 LED display indicating start of welding cycle
19 LED welding current
20 Lit mains switch.
21 Safety fuse
22 Mains cable