Würth 5701 415 000, Manual

Page: 16 / 133

16
Recommended ambient charging
temperature
5 - 40°C
Recommended battery type LI 18V/2 Ah BASIC
LI 18V/4 Ah BASIC
LI 18V/5 Ah BASIC
Recommended charger ALG 18/4 BASIC
ALG 18/6 FAST
Know Your Product
See page 3.
1. LED light
2. Chuck
3. Direction of rotation selector
4. Trigger switch
5. Handle, insulated gripping surface
6. Mode selection button
7. Speed selection button
8. Battery pack
9. Belt clip
Intended Use
The impact driver is intended for fastening and removing screws and
bolts.
For damage caused by usage other than intended, the user is
responsible.
Control panel
Mode: Tek screw
Use this mode to drive self drilling screws into
metal. This mode starts at a high speed to facilitate
hole drilling and then lowers the speed when
driving in the screw.
Mode: Assistance
Use this mode to drive screws when better control
is required. This mode starts at a lower speed and
WKHQLQFUHDVHVWRÀQLVKGULYLQJLQWKHVFUHZ
In reverse direction, this mode rotates in 6 pulses
moving up to a controlled reverse speed designed
to remove screws with damaged heads.
Mode: Auto tight
Use this mode to avoid overdriving the nut or bolt.
In this mode, the product will automatically stop
after it has impacted on the fastener.
Speed: 1
Use this mode to drive small fasteners when lowest
speed and force are required.
Speed: 2
Use this mode to drive medium-sized fasteners
when medium force and speed are required.
Speed: 3
Use this mode to drive large fasteners when
maxmium force and speed are required.
Symbols
Read all safety warnings and all instructions.
Warning
V Volts
Direct current
No-load speed
CE conformity
EurAsian Conformity Mark
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
local authority or retailer for recycling advice.
Battery
A battery that is new or has not been used for a longer period does
not develop its full capacity until after approx. 2 – 3 charging/
discharging cycles.
Do not place down the battery on radiators or expose it to intense
sunlight for longer periods; temperatures above 50 °C cause damage.
Keep the contacts/terminals of the charger and replaceable battery
clean. For optimal service life, fully charge the battery after use.
Dust Extraction
Dusts from materials such as lead-containing coatings, some wood
types, minerals and metal can be harmful to one’s health. Touching
or breathing-in the dusts can cause allergic reactions and/or lead to
respiratory infections of the user or bystanders.
Certain dusts, such as oak or beech dust, are considered carcinogenic,
especially in connection with wood-treatment additives (chromate,
wood preservative). Materials containing asbestos may only be
worked on by specialists.
˟
Provide for good ventilation of the working place.
˟ ,WLVUHFRPPHQGHGWRZHDUD3ÀOWHUFODVVUHVSLUDWRU
2EVHUYH WKH UHOHYDQW UHJXODWLRQV LQ \RXU FRXQWU\ IRU WKH PDWHULDOV
being worked on.
Maintenance and Cleaning
˟ Disconnect the plug from the power source and/or the battery
pack from the power tool before making any adjustments,
changing accessories or storing power tools. Such preventive
safety measure reduce the risk of starting the power tool
accidentally.
˟ For safe and proper working, always keep the product and
ventilation slots clean.