Installation manual for LED indicator
• Revision: 00 • 28/04/2021 •
© ABM Fahrzeugtechnik GmbH
Page 2 of 4
Caution
Important safety advice:
Working on motorcycles poses a safety risk. Some work may only be carried out by appropriately
qualified personnel. Faulty work can have serious consequences and may pose a threat to life and
health. Only undertake installation works if you are sufficiently qualified and have an official workshop
manual as well as all relevant service notifications available. Otherwise, we strongly recommend that
the installation is carried out or at least checked in a specialist workshop.
Any work in relation to the installation, removal and tightening torque of original parts should always
be carried out in compliance with the workshop manual.
All screws must be attached with thread-locking fluid. However, this should only be done after the
installation is complete.
It is your responsibility to check the product regularly and to determine if a service or replacement is
required.
Please bear in mind that some products are safety-relevant parts of your vehicle. After a fall or collision,
check the product and if there is the slightest indication of damage, you must replace it.
Some products require registration.
These products have been designed for a standard vehicle. ABM® Fahrzeugtechnik GmbH makes no
warranty or guarantee of any kind for any damages whatsoever arising out of the combination with
other component parts not tested by ABM, as a consequence of improper installation or inadequate
maintenance.
1
Preparation
Please read the entire safety information and installation manual carefully.
A motorcycle not securely positioned can fall over during the following work. Therefore, make sure
that the motorbike is positioned on solid, flat ground and is secured against falling over and rolling
away.
Keep children and pets away from the work area.
Protect removed parts from damage.
Please note when disassembling individual parts which screws are used to fasten them. Keep these
parts and screws and unless specified otherwise, reuse when assembling.
