Precautions
All User Manuals and leaflets should be read thoroughly before proceeding with operation of the
equipment
It is also advisable that all User Manuals and Instruction Leaflets supplied are kept readily available,
for reference when the equipment is in general use
The following precautions must be adhered to at all times and must be considered in addition to any
advised precautions issued at the relevant worksite or work area
•
Do not supply power to
IR136
Thermal Camera beyond the followed requirement:
DC +24V
（
±1V
）
AC 110V-240V, 50-60 Hz, power rate
≥
50W
•
You will use PC, monitor, power and etc with
IR136
Thermal Camera, so it is highly
recommended to connect all the electric systems with ground
•
It is highly recommended to use
IR136
Thermal Camera statically although it is static
protected. By this, to avoid any damage to the precise electronics inside the camera
•
Do not frequently power on/off the camera. Time between on and off should be not less
than 30 sec.
•
Do not pull in/out power cord, video cable, control cable etc. when the camera is on; And
highly recommended to cut off power of all the connected electric systems like monitor
when pulling in/out all the cables.
•
Do not direct the
IR136
Thermal Camera at very high intensity radiation sources such as the
sun, carbon dioxide lasers or arc welders etc
•
Do follow the environmental conditions as follows:
Storage Temp: -45
℃
～
65
℃
Work Temp: -40
℃
～
55
℃
Vibration: 5-500 Hz, 12.7mm peak
Shock: 20G, 11ms
3
Summary of Contents for IR136
Page 24: ...24...
