wtw OxiTop C, Operating Manual

Page: 20 / 82

Operating mode: BOD Standard / BOD Routine OxiTop
®
Control OC 100
20
ba31114e06 06/2012
Confirm the selected
measurement range for the
sample. The automatically
assigned sample number
(YY/MM/DD and sequential
number) is given in the header
line.
Additional information:
 Type of measurement, run duration, measurement range,
final date, ID number.
 Temp display => the AutoTemp function (see section 7.1
GLP/TOOLS
MAIN MENU
, page 38) is switched on.
 GLP display => the GLP function (see section 7
GLP/TOOLS, page 38) is switched on.
Change the ID number for the additional identification of the
sample (e.g. sampling location) as follows:
 Select the - I.D. number menu item with <  ><  >

Confirm
with <RUN/ENTER> .
 Set the required ID number (setting range 001 ... 255) with
<

><

> .
 Confirm with <RUN/ENTER> .
Use <PRINT> to print out the entire sample information (in BOD
Routine mode only), see section 6 P
RINTING
, page 36).
Confirm the start of
measurement. Contact selection:
The controller repeatedly sends the start information in the
scanner mode until successful feedback is received from the
OxiTop
®
-C measuring head. After the successful start message
from the measuring head:
Displays ! started !
From this point in time, the sample
exists within the
SAMPLE STATUS TYPE
list
(
sample management).
Subsequently, the request to
start the next measuring head is
made automatically.
RUN/ENTER
RUN/ENTER