Repair
It is recommended that the suit be sent for inspection to your local WSS service station for
checking if the suit has been repaired on board. The repair kit is supplied with the portable
test kit so that suit can be made functional and can be used in case of emergency. In order
to be sure that the suit retains its functional performance after on board emergency repair,
please get the suit inspected by your local WSS service station.
1.
Repair the leakage suit after dry, please use the spare repair pieces for repair.
2.
Spread the glue twice evenly on the leak area of the internal of immersion suit over
25mm extended from the leak point in all directions, then cut a suitable patch with 5mm
less than the area spread on the suit in all directions and spread the glue twice evenly
on the patch, under normal temperature and normal humidity, the interval between the
two spreading is about 4 to 5 mins.
3.
Stick the patch onto the leak area after 4 to 5mins and press them by the roller carefully.
4.
Do the water tightness test again.
5.
Check all reflective tape is in place and glued tightly, they may damage after testing use
or long time storage, in this case we recommend repair or renew by service station for
best adhesion.
3.
Stick the patch onto the leak area after 4 to 5mins and press them by the roller carefully.
