wsm m9540, Workshop Manual

Page: 69 / 73

L9-S8
M9540Low Profile, WSM ELECTRICAL SYSTEM
[2] 4WD / BI-SPEED TURN SYSTEM
(1) Switch
4WD / Bi-speed Turn Switch
1. Turn the main switch off.
2. Remove the 4WD / bi-speed turn switch (1).
W1013236
1) Connector Voltage
1. Turn the main switch to ON position.
2. Measure the voltage with a voltmeter across the connector R/G
terminal and chassis.
3. If the voltage differs from the battery voltage, the wiring harness
is faulty.
W1013370
2) 4WD / Bi-speed Turn Switch
1. Check the continuity through switch with an ohmmeter.
2. If continuity specified below are not indicated, the switch is faulty.
W1013578
Turning Angle Inspection Switch
1. Remove the switch cover (3) from the left side front case support
(4).
2. Disconnect the turning angle inspection switch connector (2)
after turning the main switch off.
3. Perform the following checking 1) and 2) .
W1013809
(1) 4WD / Bi-speed Turn Switch
Voltage R/G terminal – Chassis Battery voltage (11 to 14 V)
(1) 4WD / Bi-speed Turn Switch
(2) 4WD / Bi-speed Turn Switch
Connector (Switch Side)
(3) 4WD / Bi-speed Turn Switch
Connector (Wiring Harness Side)
Terminal
Position
D B T IL
OFF
O
DT
O O
Bi-speed
O O O O
(1) 4WD / Bi-speed Turn Switch
(2) 4WD / Bi-speed Turn Switch
Connector (Switch Side)
(3) 4WD / Bi-speed Turn Switch
Connector (Wiring Harness Side)
(1) Turning Angle Inspection Switch
(2) Connector (3) Switch Cover
(4) Front Case Support
KiSC issued 09, 2008 A