wsm m9540, Workshop Manual

Page: 18 / 73

LG-3
M9540Low Profile, WSM G GENERAL
(2) Rear Wheels
Rear tread width can be adjusted as shown with the standard
equipped tires.
To change the tread width
1. Remove the wheel rim and / or disc mounting bolts.
2. Change the position of the rim and disc (right and left) to the
desired position, and tighten the bolts.
IMPORTANT
Q
• Always attach wheels as shown in the figure.
• If not attached as illustrated, transmission parts may be
damaged.
• When re-fitting or adjusting a wheel, tighten the bolts to the
following torques then recheck after driving the tractor 200
m (200 yards) and thereafter according to service interval.
(Refer to “[5] CHECK POINTS OF EVERY 50 HOURS” at
“7. CHECK AND MAINTENANCE”.)
W1082792
Tightening
torque
Rear wheel mounting
nut
M18
343 to 401 N·m
35.0 to 41.0 kgf·m
254 to 297 lbf·ft
Rear disc mounting nut M16
259.9 to 304.0 N·m
26.5 to 31.0 kgf·m
191.7 to 224.2 lbf·ft
Tread (a) A B C D E
480/70R28
1515 mm
59.65 in. 1585 mm
62.40 in. 1723 mm
67.83 in. 1777 mm
69.96 in. 1915 mm
75.39 in.
(1) Rear Wheel Mounting Nut
(2) Rear Disc Mounting Nut (3) Rear Wheel Disc (4) Rear Wheel Rim (a) Tread
KiSC issued 09, 2008 A