WRIGHT stander zk 75180, Instruction Manual

Page: 15 / 44

15
Warning, shield missing, DO NOT
operate with shields missing. Keep
shields and covers in place.
Warning, rotating blades, Keep
hands, feet and clothing away from
rotating blades. Use safety
glasses to avoid thrown material.
To inspect blades or clean under
side of cutter deck, apply parking
brake and remove ignition key.
Warning, crush hazard. Be aware
of your surroundings at all times.
Always stop the machine if
someone enters the area.
Warning, denotes potential hazardous situation which, if not
avoided, could result in minor to serious injury or death
Caution, rotating pulleys and belts. Keep shields and
covers in place while machine is in operation. Keep hands
feet and clothing away from rotating pulleys and belts.
Caution, Battery hazard. Avoid skin contact with battery
acid. Do not allow open flame near the battery when
charging. Always where eye protection when checking the
battery.
Caution, hot surface! Avoid skin contact with hot surface
Warning, potential fire, clean flammable material away from
machine. Clean engine fins and exhaust heat shield of any
debris build up. Inspect fuel lines for wear and replace when
worn. Always clean up spilled fuel and oil.
Caution, hydraulic fluid under pressure, potential skin
puncture. Do not check for leaks with mower running.
Caution, denotes potential hazardous impeller condition
when using the rear bagging system, could result in cutting
of fingers or hand while machine is in operation. Keep all
shields and covers in place.
Warning, thrown objects. Never operate the mower deck
with the chute deflector damaged, altered, removed or in the
raised position, except when using a Grass Gobbler, rear
collection system or mulching system is being used.
Warning, rollover. DO NOT operate near drop-offs, retaining
walls, drainage ditches, water and other types of hazards to
avoid a wheel dropping over the edge or to avoid the ground
from breaking away.
Warning, reduce speed and exercise extreme caution on
slopes and on sharp turns to prevent tipping or loss of
control
3 Specifications
Engine

See your engine owner’s manual

RPM: Full speed 3600 +/- 50 RPM (no load) / Idle: 1550 RPM
Electrical System

Charging System: Internal stator coil

Battery Type: Maintenance free

Battery Voltage: 12 Volts

Fuses: Two, 20 amp blade type