BASE UNIT
800 2/3 Drawer
Carcass Assembly
For Internal Use: FI.WR.INS.026_WKIN00108_BASE_800_2_3Drawer_Rev3.indd
Page 9
Secure unit to wall using
space plug
.
Drill pilot hole through the back brace
into the wall and insert
wall plug. Then unwind space plug
until it contacts both surfaces.
Finally, tighten the screw.
Screws for attaching to walls are
not provided as these vary
depending on your wall material and
construction. Ensure appropriate
fixings for wall construction are used.
Securing to Adjacent Units
Screw into any side units using
the 30mm screws
(K)
provided to
secure to unit. Screw just to the rear,
at the top and bottom of both sides
of the unit, place a cover cap
on the head to conceal it.
L Brackets
Use 2 x 15mm screws
(J)
to secure each
of the L brackets to the cabinets at either side.
Then screw up through into the worktop as shown.
Screws for attaching to worktop are
not supplied as these vary depending
on worktop material and thickness. Ensure
appropriate fixings for attaching worktop are
used. L brackets should only be fitted for securing
wood and laminate worktops, please refer to the
specialist worktop supplier if these are required
for solid surface worktops.
Worktop
Screw up through the front rail into
your worktop to secure it in place.
Screws for attaching to worktop are
not supplied as these vary depending
on worktop material and thickness. Ensure
appropriate fixings for attaching worktop are
used. Please refer to the specialist worktop
supplier if these are required for solid
surface worktops.
J
J
K
