PZM
IV
& PZMT
IV
World Precision instruments
6
Operation
refer to
Figure 1
on page 3 and system diagram on page 4 along with the
following instructions on normal operation.
1. Set Up Microscope on Track Stand
mount the microscope head into the focus mount. use focusing knob to bring
microscope to focus.
2. Interpupilary Distance Adjustment
looking through the eyepieces with both eyes, adjust the interpupillary
distance by sliding the two eyepiece tubes with both hands until a single
image is observed.
3. Focus Adjustment
Place a sample under the microscope, turn magnification knob
(4)
to its
greatest setting (5.0). Focus the image by turning the focusing knob
(7)
.
once image is in clear focus at its highest magnification you may zoom out
to lower magnification by adjusting magnification knob
(4)
while remaining in
focus.
4. Diopter Adjustment
if image does go out of focus when zooming out, zoom to the lowest setting
and focus each eyepiece individually by adjusting the diopter adjustment ring
(2)
.
5. Video/Photo Applications
slide the light path selector bar
(13)
to the “PHoto in” position in order
to direct the light to the video/photo port
(12)
. remove the protective cap
on top of the video/photo port. slip and secure the body of c-mount ccd
camera coupler
(11)
over the
video/photo port, with its focus ring facing
back. Attach c-mount video or digital camera (when using cameras with an
integrated lens filter thread of 8, 37 or 43 mm, digital camera Adapter Kit
#501384
is required). refer to camera’s manual for connecting camera to
monitor. Focus image on screen by adjusting the fine focus ring located at the
back of the c-mount ccd camera coupler
(11)
.
