4K Wallplate HDBaseT Transmitter
8
5. Button Control
SOURCE/AUTO Button
Press and hold the
SOURCE/AUTO
button for approximately 3 seconds. When the
button lights up green the transmitter is in AUTO mode. This mode automatically
selects the last video source connected to the transmitter and outputs it to the display. If
press and hold again for approximately 3 seconds, the light will go out, and the device
will be in Manual mode which will allow the user to momentarily press the button to
toggle between the two HDMI sources.
6. RS232 Control
6.1 RS232 Control Connection
There are two RS232 control modes switching via sending 50779% or 50780%.
①
Control this transmitter and far-end third-party device (such as projector) device
by local PC, and the connection diagram shown as below:
Projector/Flat Screen Display
Tx
Rx
HDMI OUT
HDBT IN
RS232
IR IN
IR OUT
PoC
HDBaeT Receiver
1
2
V
T
x
R
x
OUT
RS232
H
D
B
T
O
U
T
PC
Cat 5e/6A
Cat 5e/6A
Wallplate HDBaeT Transmitter
HDBaseT:
RS232: