Woxcon IPA100, User Manual

Page: 41 / 60

4K IP Streaming Extender
35
5.10 Global Command Options and Settings
To access a device’s options, left-click the gear icon of any connected TX or RX
Note: Device options can be accessed from any detected device and from any of the
interface tabs, "Video Switching", "HDMI Audio", etc.
5.10.1 Receiver (RX) Settings Options
The following section illustrates the Receiver (RX) device settings dialog box.
5.10.1.1. Analog Audio Output Settings
Use this tab to select the audio source to be sent to the analog audio output port.
There are two audio source options:
l
HDMI Audio (Downmix): 2-channel downmix of the original HDMI audio from a TX.
l
Analog Audio: Analog audio stream, directly coming from the analog input on a TX.
5.10.1.2. HDMI Audio Output Settings
Use this tab to control, which audio source is output via HDMI. There are four options.
l
HDMI Audio (from HDMI, "Genlock Mode"): The original HDMI audio stream
received with the video is used, if the RX device is in "Genlock Mode" or if the RX
device does not receive a separate HDMI audio stream (in any video mode).
l
Analog Audio: Select the analog audio stream of the TX to embed it into the HDMI
output.
l
HDMI Audio (Stereo Downmix): Select the HDMI audio stream of any TX as
separate HDMI audio stream and embed it into the HDMI output signal. If the HDMI
audio stream is a multichannel PCM format, it will be downmixed to 2-channel
stereo audio at the output.
l
HDMI Audio (All Available Channels): Select the HDMI audio stream of any TX as
separate HDMI audio stream and embed it into the HDMI output signal. The
multichannel HDMI audio will not be downmixed.