Worx WX420, Manual, Page: 15 / 140

Mini circular saw EN
15
ENVIRONMENTAL
PROTECTION
Waste electrical products should not
be disposed of with household waste.
Please recycle where facilities exist.
Check with your local authorities or retailer for
recycling advice.
TROUBLESHOOTING
Symptom Possible Causes Possible Solution
tool will not start when
operating the on/off switch.
Power cord not plugged in.
Power cord is broken.
Carbon brush has worn
down.
Check to make sure power cord
is connected well into a working
outlet.
Unplug the power cord. Replace
it using a qualified maintenance
person.
Replace the carbon brush using a
qualified maintenance person.
Cutting depth is less than that
is set. Sawdust accumulated at the
rear of the base.
Shake out sawdust. Consider
connecting a vacuum for dust
collection.
Blade spins or slips.
Blade is not tightly engaged
with the spindle.
Remove the blade, and
reassembled it as described in
INSTaLL/CHaNGE THE BLaDE
section.
Blade will not cut a straight line.
Blade is dull.
Blade is not mounted
properly.
Saw is not being guided
properly. Mount a new, sharp blade on the
saw.
Check that blade is properly
mounted.
Use an edge guide.
Blade kicks back when
beginning a cut.. Blade is not spinning fast
enough Allow the saw blade to reach full
speed prior to beginning a cut.