Worx WX382, Original Instructions Manual

Page: 11 / 112

Cordless rotary hammer EN
11 10
rotation.
wARNING: Never change the
direction of rotation while the tool
is rotating, wait until it has stopped.
6. FUNCTION MODE SELECTION
(See Fig. E)
The operation of the gearbox for each
application is set with the function mode
selection switch (8). To change between
functions, depress the unlocking button
(15) and rotate the selector to the desired
operating mode.
For simultaneous
drilling and impacting
of concrete or masonry,
choose the Hammer
drilling position.
For screw driving,
drilling into steel, wood
and plastics choose the
Rotary drilling position.
wARNING: The operating mode
selector switch may be actuated
only at a standstill.
7. LED LIGHT (See Fig. F)
To turn on the light simply press the on/off
switch. When you release the on/off switch,
the light will be off.
LED lighting increases visibility-great for
dark or enclosed area. LED is also a battery
capacity indicator. It will flash when power
gets low.
8. TEMPERATURE DEPENDENT
OVERLOAD PROTECTION
When using as intended for, the power tool
cannot be subject to overload. When the
load is too high or the allowable battery
temperature of 75°C is exceeded, the
electronic control switches off the power
tool until the temperature is in the optimum
temperature range again.
9. PROTECTION AGAINST DEEP
DISCHARGING
The Li-Ion battery is protected against deep
discharging by the “Discharging Protection
System”. When the battery is empty, the
machine is switched off by means of a
protective circuit: The inserted tool no longer
rotates.
WORKING HINTS FOR YOUR
TOOL
If your power tool becomes over heated, set
the speed to maximum and run no load for 2-3
minutes to cool the motor. SDS-plus tungsten
carbide drill bits should always be used for
concrete and masonry.
When drilling in metal, only use HSS drill bits
in good condition. Where possible use a pilot
hole before drilling a large diameter hole.
PROBLEM SOLUTION
REASONS FOR DIFFERENT BATTERy
PACK wORKING TIMES
Charging time problems, having not used a
battery pack for a prolonged time will reduce
the battery pack working time. This can be
corrected after several charge and discharge
operations by charging & working with your
drill. Heavy working conditions such as large
screws into hard wood will use up the battery
pack energy faster than lighter working
conditions. Do not re-charge your battery pack
below 0
o
C and above 30
o
C as this will affect
performance.
MAINTENANCE
Remove the battery pack from the tool
before carrying out any adjustment,
servicing or maintenance.
Your power tool requires no additional
lubrication or maintenance ,except for the
cleaning & lubrication of the SDS bits and
adaptors before inserting into the chuck.
There are no user serviceable parts in your
power tool. Never use water or chemical