Worx WX382, Original Instructions Manual

Page: 10 / 112

Cordless rotary hammer EN
11 10
OPERATING INSTRUCTIONS
NOTE:
Before using the tool, read the
instruction book carefully.
INTENDED USE
The machine is intended for hammer drilling
in concrete, brick and stone. It is also suitable
for drilling without impact in wood, metal,
ceramic and plastic. Machines with electronic
control and right/left rotation are also suitable
for screwdriving.
BEFORE PUTTING INTO OPERATION
A) CHARGING THE BATTERy PACK
The battery pack charger supplied is matched
to the Li-Ion battery installed in the machine.
Do not use another battery charger.
The Li-Ion battery pack is protected against
deep discharging. When the battery pack is
empty, the machine is switched off by means
of a protective circuit: The chuck no longer
rotates.
In a warm environment or after heavy use, the
battery pack may become too hot to permit
charging. Allow time for the battery pack to
cool down before recharging.
When the battery pack is charged for the first
time and after prolonged storage. The battery
pack will accept a 100% charge after several
charge and discharge cycles.
B) TO REMOVE OR INSTALL BATTERy
PACK (See Fig. A)
Depress the battery pack release button to
release and slide the battery pack out from
your tool. After recharge, slide it back into your
tool. A simple push and slight pressure will be
sufficient.
OPERATION
1. INSERTING AND REMOVING DRILL
BITS & ADAPTORS (11, 13) IN THE SDS
CHUCK
Take care that the dust protection cap
(1) is not damaged when changing tools.
— INSERTING (See Fig. B1, B2)
Clean and lightly oil the bit before inserting.
Insert the dust-free bit into the bit holder with
a twisting motion until it latches.
The bit locks itself. Check the locking by
pulling on the tool.
— REMOVING (See Fig. B3)
Retract back the bit holder locking sleeve (2)
and pull out the bit.
wARNING: your new wORX Rotary
Hammer Drill generates powerful
forces to get your job done quickly and
effectively. These forces may cause
inferior quality SDS bits to break and jam
in the chuck, we therefore recommend
that only high quality SDS bits be used
with this tool.
2. INSERTING A TOOL INTO CHUCK (13)
(See Fig. C)
To open the chuck jaws rotate the front section
of the chuck while holding the rear section.
Insert the drill bit between the chuck jaws
and rotate the front section in the opposite
direction while holding the rear section.
Ensure that the drill bit is in the center of
the chuck jaws. Finally, firmly rotate the two
separate chuck sections in opposite directions.
Your drill bit is now locked in the chuck.
3. ON/OFF SwITCH (See Fig. D)
Depress the On/Off switch (4) to start and
release it to stop your tool.
— ON/OFF SwITCH wITH VARIABLE
SPEED CONTROL
Depress the On/Off switch to start and release
it to stop your tool. This tool has a variable
speed switch (4) that delivers higher speeds
with increased trigger pressure - speed is
controlled by varying the pressure applied to
the switch.
4. SwITCH LOCK (See Fig. D)
The switch trigger can be locked in the OFF
position. This helps to reduce the possibility of
accidental starting when not in use. To lock the
switch trigger, place the direction of rotation
control in the center position.
5. FORwARD AND REVERSE ROTATION
CONTROL (See Fig. D)
With the hammer pointing away from you,
push the forward/reverse-lever “
“ to the
left for forward rotation. Push the forward/
reverse-lever “
“ to the right for reverse