Cordless rotary hammer
WX382 WX382.1
WX382.2 WX382.3 WX382.4
12
9
F
15
E
6. FUNCtIoN MoDE SElECtIoN (See Fig. E)
The operation of the gearbox for each application is set
with the function mode selection switch (8). To change
between functions, depress the unlocking button (15)
and rotate the selector to the desired operating mode.
For simultaneous
drilling and impacting
of concrete or masonry,
choose the Hammer
drilling position.
For screw driving,
drilling into steel, wood
and plastics choose the
Rotary drilling position.
WARNING: the operating mode selector
switch may be actuated only at a standstill.
7. lED lIGHt (See Fig. F)
To turn on the light simply press the on/off switch.
When you release the on/off switch, the light will be off.
LED lighting increases visibility-great for dark or
enclosed area. LED is also a battery capacity indicator. It
will flash when power gets low.
8. tEMPERAtURE DEPENDENt ovERloAD
PRotECtIoN
When using as intended for, the power tool cannot be
subject to overload. When the load is too high or the
allowable battery temperature of 75 °C is exceeded,
the electronic control switches off the power tool until
the temperature is in the optimum temperature range
again.
9. PRotECtIoN AGAINSt DEEP DISCHARGING
The Li-Ion battery is protected against deep discharging
by the “Discharging Protection System”. When the
battery is empty, the machine is switched off by means
of a protective circuit: The inserted tool no longer rotates.
wORKING hINTS FOR YOUR TOOL
If your power tool becomes over heated, set the speed
to maximum and run no load for 2-3 minutes to cool
the motor. SDS-plus tungsten carbide drill bits should
always be used for concrete and masonry.
When drilling in metal, only use HSS drill bits in good
