Rotary hammer
WX333
WARNING!
You must make sure that the
selector switch is positively locked in chisel
mode position. If not, it could cause a hazard.
11. DUST COVER (See K)
Use the dust cover to prevent dust from falling over
the tool and on your self when performing overhead
drilling operations. Attach the dust cover to the bit as
shown in the K.
12. LUbRICATION MACHINE (See L)
The machine is grease-lubricated. A grease refill is
only required during hammer work efficiency is low.
Open the grease box lid at the top of the hammer
using the pin spanner provided. Then refill approx
30g grease provided with your tool. The grease
specification is general purpose lithium based.
Use only Worx genuine hammer grease (optional
accessory).
CAUTION:
Keep the container of grease away
f from children.
13. TO REPLACE THE bRUSHES (See M,N)
Disconnect the plug from the power supply.
Unscrew the carbon brush cap with screwdriver.
Remove the carbon brush. Check the length of the
brush and replace if under 6mm. When brushes need
replacement always renew both brushes, even if one
is still more than 6mm long.
Completely screw down the carbon brush cap. Check
that the tool is working. Before use, allow it run for a
few minutes to enable the brushes to settle.
WORKING HINTS FOR YOUR
TOOL
1. Reduce the pressure on the drill bit when it is about
to break through. This will prevent the drill from
jamming.
2. When drilling a large hole, first drill a pilot hole
using a smaller drill bit.
3. Always apply pressure to your drill bit in a straight
line, and if possible at right angles to the workpiece.
4. Never change the operating mode whilst the drill is
running.
5. Do not apply excessive pressure to the tool when
chiseling. Expressive force does not speed up the
work.
!
!
!
&
'
(
)
*
+
,
-
.
#
$
%
!
!
!
&
'
(
)
*
+
,
-
.
#
$
%
!
!
!
&
'
(
)
*
+
,
-
.
#
$
%
!
!
!
&
'
(
)
*
+
,
-
.
#
$
%
