drywall screwdriver
EN
10
OPERATING INSTRUCTIONS
NOTE:
Before using the tool, read the
instruction book carefully.
iNTENDED uSE
The machine is intended for driving in and
loosening screws.
1. FiTTiNG AND rEmOviNG BiTS (See A)
wArNiNG:
Before installing tool,
remove mains plug from mains supply.
To use any one of the short bits supplied,
insert the bit into the holder. To remove the bit,
simply pull it out of the holder.
2. ON/OFF SwiTch (See B)
Depress the switch to start the tool and release
it to stop your tool.
cONTiNuOuS uSE
Depress on/off switch (5) then lock-on button
(3), release on/off switch first and lock-on
button second. Your switch is now locked on
for continuous use. To switch off your tool just
depress and release the on/off switch.
It is also a variable speed switch that delivers
higher speed and torque with increased
trigger pressure. Speed is controlled by the
amount of switch trigger depression.
3. FOrwArD/rEvErSE SwiTch (See c)
To change the rotational direction, push the
forward/reverse selector switch to the “R”
position indicated on your screwdriver. The
rotation will now be forward rotation. Push the
forward/reverse selector switch to “L” position
indicated on your screwdriver. The rotation
will be reverse rotation.
NOTE: Never move the forward/reverse
switch whilst the screwdriver in
operation or the on/off switch is locked
as this will damage the screwdriver.
4. DEPTh ADjuSTmENT (See D)
To increase or decrease the screw depth in
the workpiece, you can turn the adjustment
collar to adjust screw depth. Turn clockwise to
decrease the screw depth and anti-clockwise
to increase screw depth.
5. chANGiNG BiT hOlDEr (See E, F, G)
Pull out the adjustment collar from the clutch
housing. Pull out the bit holder (a) from the
spindle with pliers if it is difficult to remove.
Push new bit holder into spindle until ball
lock snaps in groove (c) in bit holder shank.
Replace adjustment collar by snapping over
the clutch housing.
NOTE:
Raised bar in adjusting collar (b)
should target the groove on clutch housing.
6. BElT cliP
With the belt clip, the machine can be hung
onto a belt. The user has both hands free and
the machine is always within reach.
7. OPErATiON ScrEwDrivEr
There is a clutch in your screwdriver. Switch
on the screwdriver, the motor is running,
but the bit still can not run. When sufficient
forward pressure is applied to the bit, the
clutch engaging and rotate the spindle and
bits. A reversing switch makes it possible to
loosen screw or drive left-hand screw.
NOTE:
When screw will be tightened, please
set the switch to lower speed, to prevent
screw head from being damaged.
MAINTENANCE
remove the plug from the socket before
carrying out any adjustment, servicing or
maintenance.
There are no user serviceable parts in your
power tool. Never use water or chemical
cleaners to clean your power tool. Wipe clean
with a dry cloth. Always store your power tool
in a dry place. Keep the motor ventilation slots
clean. Keep all working controls free of dust.
Occasionally you may see sparks through the
ventilation slots. This is normal and will not
damage your power tool.
If the supply cord is damaged, it must be
replaced by the manufacturer, its service
agent or similarly qualified persons in order to
avoid a hazard.