Worx WX152, Original Instructions Manual

Page: 11 / 108

11
Lithium-Ion Cordless Drill/Driver EN
CHUCK ADJUSTMENT
WARNING:
Always lock off trigger
switch and disconnect tool from power
source when changing accessories. Always
ensure the bit is secure before starting the tool.
Damage to the Chuck or a loose bit may cause
possible personal injury.
-- Removing the bits See Fig. B1
-- Inserting the bits See Fig. B2
OPERATION
Forward/reverse rotation control
WARNING: Never
change the direction
of rotation when the chuck
is rotating, wait until it has
stopped!
See Fig.
C1, C2, C3
TWO-SPEED GEAR
CONTROL
See Fig. D
TORQUE ADJUSTMENT
DRILLING, SCREWDRIVING
See Fig. E
Operating the on/off switch
WARNING: Do not
operate for long
periods at low speed
because excess heat will be
produced internally.
See Fig. F
LED Light Indicator
Before operation, the LED light will be activated
when the On/Off switch is slightly depressed.
The tool and battery are equipped with a
protection system. When the LED Light is
quickly flashing 60 seconds and turn off, the
system will automatically cut off power to
the tool to extend battery life. The tool will
automatically stop during operation if the tool
and/or battery are placed under one of the
following conditions:
•
Overloaded
: The tool is operated in a manner
that causes it to draw an abnormally high current.
In this situation, release the Trigger Switch on
the tool and stop the application that caused the
tool to become overloaded. Then pull the Trigger
Switch again to restart.
•
Overheated:
Under the condition above, if
the tool does not start, the Tool and Battery are
overheated. In this situation, let the Tool and Battery
cool before pulling the Trigger Switch again.
•
Low battery voltage
: The remaining
Battery capacity is too low and the tool will not
operate. In this situation, remove and recharge
the Battery.
WARNING:
To turn on the light, press
the On/Off switch and make sure the
Forward/Reverse Rotation Control is on
right/left position.
PROBLEM SOLUTION
1. WHY DOES THE DRILL NOT TURN ON
WHEN YOU PRESS THE SWITCH?
The forward/reverse rotation control, which is
on top of the trigger, is positioned in the lock
function. Unlock the forward/reverse rotation
control by putting it into the required rotation
position. Push the trigger and the drill will
start to rotate.
2. THE DRILL STOPS BEFORE THE SCREW
IS COMPLETELY TIGHTENED. WHY?
Verify the torque position of the torque
adjusting ring, you can find the
torque-adjusting ring between the chuck and
the drill body. Position 1 is the lowest torque
(screw driving force) and position 15 is the
highest torque (screw driving force). Position