9
Operating instructions
Note:
Before using the tool, read the instruction book carefully.
iNteNDeD USe
The power tool is intended for sawing and separating wooden
materials, plastic, plaster, non-ferrous metals and fasteners (e.g.
nails and clamps) as well as for working on soft wall tiles and for dry
grinding of small surfaces. It is especially suitable for working close to
edges and for flush cutting.
BefoRe PUttiNG iNto oPeRatioN
a) cHaRGiNG tHe BatteRy
The battery charger supplied is matched to the Li-ion battery installed
in the machine. Do not use another battery charger.
The Li-ion battery is protected against deep discharging. When
the battery is empty, the machine is switched off by means of a
protective circuit: The tool holder no longer rotates.
In a warm environment or after heavy use, the battery pack may
become too hot to permit charging. Allow time for the battery to cool
down before recharging.
When the battery pack is charged for the first time and after
prolonged storage, the battery pack will accept a 100% charge after
several charge and discharge cycles.
B) to ReMove oR iNStall BatteRy Pack (See fig. a)
Depress the battery pack release button to release and slide the
battery pack out from your tool. After recharge, slide it back into your
tool. A simple push and slight pressure will be sufficient.
A
