12
Low oscillation frequency:
Polishing varnishes.
MoUNtiNG tHe SUctioN Device (See fig. D1, D2)
When vacuuming, mount the suction device as shown in D1-D2.
Note:
Using the sanding pad perforated. You can only do the
vacuuming after fitting the dust collector.
SaNDiNG
Typical application: wood, metal; small areas, especially corners,
edges and places difficult to access.
Select high oscillation frequency.
Sand with a constant movement and light pressure.
Heavy pressure does not increase the removal – the sanding sheet
merely wears faster.
SawiNG witH tHe SeGMeNt Saw BlaDe
Typical application: wood, plastics, sheet metal.
Select high oscillation frequency.
The saw blade lasts longer if the wear is distributed evenly. To ensure
an even distribution, loosen the saw blade, rotate it and retighten
firmly.
SawiNG witH tHe UNiveRSal eND cUt Saw BlaDe (See fig. e)
warning: the sawing teeth are very sharp. Do not touch
during mounting and application.
The workpiece must be inserted firmly or clamped tightly before it is cut.
Typical application: wood, metal (e. g. nails),plaster board and soft plastics.
When plunging and sawing use a slight pendulum motion, to allow
sufficient chip removal.
6
7
8
9
E
