Worx WG789E, Original Instructions Manual

Page: 14 / 224

15 14
Cordless self-propelled lawn mower
EN
before use.
1) Insert safety key (3) into the housing of the
switch box.
2) Push down the key, until safety key is fully
seated inside housing.
3) Press and hold the safety key, squeeze the
switch lever bar (2) towards the handle and
the mower will start.
4) Release the safety key.
STOPPING
Release the switch lever bar (2).
2. BATTERy STATUS LED’S (See J)
NOTE: Battery Status LED’s are not active
in charging mode. The Status LED’s will
indicate the battery condition when the
button on the battery is pressed.
The LED’s constantly senses and displays the
battery condition as follows:
Press the button “POWERTEST”, the light
button is illuminated.
When the three green lights are illuminated,
the battery is in a highly charged condition.
When two lights (
) are illuminated, the
battery is in a moderately charged condition.
When only one green light ( ) is illuminated,
the battery charge is depleted.
Before using your new mower for the first
time, it is recommended that the unit be
charged overnight to ensure that the battery is
fully charged.
IMPORTANT
when only one light is illuminated,
your battery is overly discharged, even
though the mower may still be capable
of cutting grass. Continuing to operate
your lawnmower with the battery in this
discharged condition may reduce the life
and performance of your battery.
3. REMOVING MULChING PLUG (See K1)
To remove the mulching plug (12) so that
you can bag the grass or discharge with the
optional discharge chute, follow the steps
listed below:
1) Shut the mower off, wait until the blade
stops and remove the safety key.
2) Raise the safety guard and hold it up.
3) Grasp the middle of the insert, lift and pull
out the mulching plug completely.
4) The safety guard is spring loaded. When
you release it, the guard will return to the
closed position.
4. INSTALLING MULChING PLUG (See K2)
1) Turn the mower off, wait until the blade
stops and remove the safety key.
2) Raise the safety guard and hold it up.
3) Slide the mulching plug (12) into the
discharge opening until it is firmly in
contact with the deck.
4) Release safety guard and ensure it is
properly closed.
5. wORK MODE DIAL (See L)
Status1: QUIET mode
Select QUIET mode (17) when mowing in
everyday conditions, removing approximately
20mm of grass at a time.
Status2: TURBO mode
Set the dial to TURBO mode (17) when cutting
dense or overgrown grass.
6. INSTALLING SIDE-DISChARGE ChUTE
(See M1 & M2)
Using the mulching plug and side-discharge
chute (13), the grass can be discharged from
the side of the machine.
To assemble the side-discharge insert, raise
the side-discharge cover (9) and hold it up,
position the side-discharge chute (13) onto the
hooks, then release the cover to lock the side-
discharge insert into position.
7. Pacesetter
TM
SELF-PROPEL DRIVE
SySTEM (See N1 & N2)
To operate the self-propel drive, hold the
switch lever (2) down to the handle and walk
with your hands comfortably gripping the
upper handle and your elbows at your sides.
The faster you walk the faster the mower will
travel.
To stop the self propel drive, simply stop
walking, or release the switch level (2).
NOTE:
The Pacesetter™ drive system will
operate with or without the mower blade
turned on.