Chain saw
WG305E
15
OPERATION
1. SWITCHING ON AND OFF (See Fig. G)
ATTENTION: Check the voltage and current
supply: The voltage and current supply must
comply with the ratings on the product plate.
For switching on the tool, press the Lock-Out Button (3),
then fully press the On/Off Switch (2) and hold in this
position. The Lock-Out Button can now be released.
For switching off, release the On/Off Switch.
2. CHAIN BRAKE (See Fig. H)
The chain brake is a safety mechanism activated through
the hand guard (7). When kickback occurs, chain stops
immediately.
The following function check should be carried out at
regular intervals as pushing hand guard (7) forwards
(position ) and start the chain saw, the chain will not
start. To deactivate the kickback brake, pull hand guard (7)
backwards (position ),and release On/Off switch (2).
3. CUTTING
IMPORTANT: Check the Oil Level Window
(4) prior to starting and regularly during
operation. Refill oil when oil level is low. A full
oil tank will last approx. 12 minutes of cutting
depending on sawing intensity and stops (See Fig.
I1).
Check recent replaced chain tension about every
10 minutes during operation.
(1) Connect saw to extension cord. Connect extension
cord to power supply. (See Fig. I2)
(2) Make sure section of log to be cut is not laying
on the ground. This will keep the chain (10) from
touching the ground as it cuts through the log.
Touching the ground while the Chain is moving is
dangerous and will dull the Chain.
(3) Use both hands to grip saw. Always use left hand
to grip Front Handle (6) and right hand to grip Rear
Handle (1). Use a firm grip. Thumbs and fingers
must wrap around saw handles (See Fig.I3 ).
(4) Make sure your footing is firm. Keep feet shoulder
width apart. Distribute your weight evenly on both
feet.
(5) When ready to make a cut, push the Lock-Out
Button (3) completely in with the right thumb
and squeeze the trigger. This will turn the saw on.
Releasing the trigger will turn the saw off. Make
sure the saw is running at full speed before starting
a cut.
(6) When starting a cut, slowly place moving chain
4
7
1
1
2
8
F
G
H
I1
I2
I3
J
K
