11
3 in 1: Trimmer / Edger / Mini mower
EN
ASSEMBLY
1. ASSEMBLY OF THE SAFETY GUARD
(See Fig. A)
Remove a screw from the Guard; attach the
Safety Guard to the trimmer head. Align the
Guard so it slides into the slots located on the
trimmer head. Turn the tool over and secure
the Safety Guard onto the trimmer head with
the screw (a) provided.
2. ASSEMBLY OF THE EDGER/TRIMMING
SUPPORT WHEELS (See Fig. B1, B2, B3)
With the tool right side up, slide the Edger/
Trimming Support Wheels (12) assembly onto
the metal plate located on the side of the
Cutting Head (See Fig. B1) or underneath the
Safety Guard (5) (See Fig. B2, B3). Make sure
the grooves of the Edger/Trimming Support
Wheels assembly locks onto the metal plate,
you will hear it click into place.
To remove the wheels assembly, press the
release button (b) on the wheel and pull the
wheels outside.
OPERATION INSTRUCTIONS
WARNING!
The charger and Battery
Pack are specially designed to work
together so do not attempt to use any other
devices. Never insert or allow foreign metallic
objects into your charger or Battery Pack
connections because of electrical failure and
other hazards that will occur.
1. BEFORE USING YOUR CORDLESS
GRASS TRIMMER
Your Battery Pack is
UNCHARGED
and it
must be fully charged once before it is used.
The battery charger supplied is matched to the
Li-Ion battery for use with this tool. Do not use
another battery charger.
2. CHARGING YOUR BATTERY PACK
(See Fig. C)
The Li-Ion battery is protected against deep
discharging. When the battery is empty, the
trimmer will switch off by means of a protective
circuit: The trimmer head will stop rotating.
NOTE:
In a warm environment or after heavy
use, the Battery Pack may become too hot to
permit charging. Allow time for the battery to
cool down before recharging.
3. CHECKING THE BATTERY CONDITION
(ONLY FOR WG160.4) (See Fig. D)
4. TO REMOVE OR INSTALL BATTERY
PACK (See Fig. E)
Depress the battery release button to remove
Battery Pack (2) from your trimmer. After
recharging, insert the Battery Pack onto
trimmer’s battery bracket. A simple push and
slight pressure will be sufficient.
5. SAFETY ON/OFF SWITCH (See Fig. F)
The safety switch is locked off to prevent
accidental starting. Depress the Lock Off Button
(9) then depress the On/Off Switch (10) and
release Lock Off Button. Your trimmer is now
on. To switch off, just release the on/off switch.
WARNING! The cutting head
continues to rotate after the
trimmer has been switched off; wait until
it has completely stopped then lay down
the tool.
6. ADJUSTMENT OF THE TELESCOPIC
SHAFT (See Fig. G)
Step one foot on the Safety Guard, then
use one hand to pull up the Telescopic Shaft
Adjustment Trigger (8), adjust the length of
the Telescopic Shaft to the most comfortable
length. Release the Telescopic Shaft.
Adjustment Trigger to lock in position.
7. MAIN HANDLE ROTATION
(See Fig. H1, H2)
First, hold down the lower housing with your
foot and pull upward on the Upper Shaft (15).
Then rotate the Upper Shaft clockwise 90
degrees (See Fig. H1) and release; the Shaft
will be locked in position automatically (See
Fig. H2).
8. ADJUSTMENT OF AUXILIARY HANDLE
Pull up the Auxiliary Handle Locking Lever (11).
Hold the Locking Lever and rotate the Auxiliary
Handle to the most comfortable and balanced
position (See Fig. I).
Release the lever, your Auxiliary Handle has
been locked.
