11
2-in-1
Grass Trimmer/Edger
WG157E
WG157E.X
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately managed.
WARNING!
To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing the
job. This may significantly reduce the exposure level
over the total working period.
Helping to minimize your vibration exposure risk.
ALWAYS use sharp chisels, drills and blades.
Maintain this tool in accordance with these instructions
and keep well lubricated (where appropriate).
If the tool is to be used regularly then invest in anti
vibration accessories.
Plan your work schedule to spread any high
vibration tool use across a number of days.
OPERATING INSTRUCTIONS
NOTE:
Before using the tool, read the
instruction book carefully.
Intended Use
The machine is intended for the cutting of grass and
weeds under bushes, as well as on slopes and edges
that can not be reached with the lawn mower.
WARNING!
The charger and Battery Pack are specially
designed to work together so do not attempt to use
any other devices. Never insert or allow foreign
metallic objects into your charger or Battery Pack
connections because of electrical failure and other
hazards that will occur.
WARNING!
Always wear the eye protection. Never lean
over the trimmer head. Rocks or debris can ricochet
or be thrown into eyes and face and cause blindness
or other serious injury. When operating unit, check
for the following:
Wear eye protection and heavy clothing. Hold front
handle with one hand and Auxiliary Handle with
the other hand. Keep unit below waist level. Work
only from your right to your left to ensure debris is
thrown away from you. Without bending over, keep
line near and parallel to the ground (perpendicular
when edging) and not crowded into material being
cut.
WARNING!
Make sure that line is fed out before operation.
Make sure motor is up to full speed before trimming
or edging.
WARNING!
Only use 1.65mm diameter cutting line. Other
sizes of line will not feed properly and will result in
improper cutting head function or can cause serious
injury. Do not use other material such as wire,
string, rope, etc. Wire can break off during cutting
and become a dangerous projectile that can cause
serious injury.
Action
Figure
Assembly
Assembling the Main Handle
Note:
Make sure that the handle is
firmly locked in place. Do not try to
remove these pieces after connecting.
See Fig. A
Assembling the Safety Guard
WARNING!
Make Sure the
Safety Switch is Locked Off
to Prevent Accidental Starting.
See Fig. B1, B2
Removing/Installing Battery Pack
Note:
When removing the battery
pack, hold it firmly to avoid
potential accidents.
See Fig. C1, C2
Charging Battery Pack
More details can be found in
charger’s manual.
See Fig. C3
Operation
Safety ON/OFF Switch
WARNING!
The cutting
head continues to rotate after
the trimmer has been switched off;
wait until it has completely stopped
then lay down the tool.
See Fig. D
Trimming
See Fig. E
Edging
WARNING!
Always remove
the battery pack before
adjusting the trimming head position.
Note:
The trimmer head will only
rotate in one direction.
See Fig. F, G
Manually Feeding the Line
See Fig. H
Removing the Cap
See Fig. I1, I2
Replacing the Trimmer Line and
Spool
See Fig. J
Manually Winding the Line
See Fig. K1-K4
