Worx WA0163, Manual

Page: 7 / 16

7 6
Extension Pole For JAWSAW
TM
En
7 6
SAFETY InSTRUCTIOnS
WArNiNg: read and understand
all instructions.
Failure to follow all
instructions listed below may result in serious
personal injury.
1. When using the extension pole to cut the
branches on a tree, make sure to keep a
firm footing and balance. Do not stand in a
position where the branch may land after
being cut.
2. When using this machine with the
extension pole, make sure to attach the
power cord of the machine to the power
cord of the extension pole firstly, and then
attach the power cord of the extension
pole to power supply.
OPERATInG InSTRUCTIOnS
NoTE:
Before using the tool, read the
instruction book carefully as well as the
instruction book of JawSaw WG307/WG308.
This extension pole is designed for use with
WORX JawSaw WG307/WG308.
ASSEMBLY
WArNiNg: Before attaching the
extension pole, make sure that the
tool is switched off and unplugged.
1. Turn the release lever to allow the handle
clamp to spring open (See Fig. A).
2. With the pole slightly angled away from
the tool, insert the steel tab into the slot
behind the front handle, then swing the
pole towards the tool’s rear handle (See
Fig. B).
3. Position the pole handle clamp inside the
tool’s rear handle as shown in Fig C. To
allow the clamp to properly fit the handle,
push lock-out button and depress the
trigger.
4. Close the clamp, the locking lever will
automatically lock into place.
5. Check that the rear handle is properly fitted
to the clamp and check that the clamp is
properly set in the lock position.
6. Plug in the tool’s power cord to the
extension pole power cord 1 . (See Fig. D)
WArNiNg! Before attaching the
power cord of the tool to the
power cord of the extension pole ( 1
in Fig. D), make sure that the tool is
switched off and unplugged from the
power supply.
WArNiNg! When using the tool
with the extension pole, make sure
to attach the power cord of the tool to
the power cord of the extension pole,
and then attach the power cord of the
extension pole to power supply.
WArNiNg! ELEcTrocuTioN
hAZArD
Never use the JawSaw or extension
pole in an area with overhead power